WALTHER-WERKE SERVICE CASE WITH LOAD SIMULATION UP TO 63A FOR TYPE1 AND TYPE 2 ; 780121024
WALTHER EV tester/simulator type 1 and type 2 as service case Dimensions approx.: 190 x 400 x 310 mm / HxWxD By means of the EV tester/simulator, the functions of...
Trenutno nema na stanju
WALTHER EV tester/simulator type 1 and type 2 as service case Dimensions approx.: 190 x 400 x 310 mm / HxWxD By means of the EV tester/simulator, the functions of charging devices for electric vehicles (charging stations, Wall boxes etc.) and plug-in charging cables (Mode 3) can be tested by simulating the electric vehicle. Functions: - Coding resistance measuring (PP) of connectors type 2 - Measuring of proximity control resistance (CS) of connector type 1 - 4 cable encodings (13/20/32/63 A) can be set via toggle switch in connection with the measuring line (special version) - Checking of PE connection between PWM and vehicle - Simulation of a leakage current > 30 mA from L1 to PE - Simulation of vehicle status B, C, D and indication - Charging voltage (L1,L2 and L3) via 3 LEDs - CP test jack for PWM signal - Load simulation via isolated ground receptacles sockets max. 6 A (L1) - 5 measuring contact sockets (L1, L2, L3, N and PE) equipped with: Laterally installed: Vehicle inlet type2, measuring contact sockets vehicle inlet type1 and isolated ground receptacle Measuring line (special version)
TECHNICAL DATA
Simulation vehicle status
✓
Simulation conductor cross section
✓
Simulation fault current
✓
Status display charging process
✓
Test PE connection
✓
Measuring resistance charging connector
✓
Signal output
✓
Connection type 2
✓
Model
Case
Width
400 mm
Height
190 mm
Depth
310 mm
Weight
4800 g